RE: Cutting 1.6mm Aluminium sheet
askaluadmin > 01-30-2018, 06:05 AM
I think you should try them, in wood or plastic. Test cuts are a way of life. Make sure your file works in something softer first and then move up to metal. Save a ton of bits that way, might also be best to start with some cheaper ones. The expensive ones usually have very specific purposes and at $30 you might have the wrong ones. Some require coolant some will not work with coolant, etc.
You are talking about speed settings in estlcam control, are you positive you didn’t upload them the the board? How do you actually run your files?
You can watch some videos from the video page and do some visual comparisons to see if your speed is at least close.