Hello,
I give a first try to aluminum today.. Clean with an SS brush and acetone. I'm using 3/32 2% lanth that I balled. Balance is at 35% I have an Everlast that work backwards.( so 65% ), 120hz. And when I hit the pedal, the arc is unstable and moving around the tip until the puddle is created. After that its going ok, but at the end, when i slow down the amp, the arc stop instead of getting smaller.. Here's a few pictures of the test..
any input?
Please help
I didn't find the right solution from the internet.
References:
http://forum.weldingtipsandtricks.com/vi...15&start=0
Video content service
Thank you