ask aluminium Forum

Aluminum Tread Plate is a product we often use, but what about the aluminum Tread Plate that some users buy? In fact, the aluminum plate is mainly caused by the production technology of some aluminum plate manufacturers. The production technology is not good, and the naturally produced Aluminum Tread Plate is easy to be brittle.

The specific reasons are mainly concentrated in the following three aspects:

1. The die section design is unreasonable: improper distribution of the internal ribs and the interface angle will cause stress concentration, which will cause the Aluminum Tread Plate to be brittle, and it is necessary to improve the design and eliminate the right angle and acute angle at the interface.

2. Insufficient pressure on the die: The pressure at the die is directly determined by the compression ratio of the die, especially the length of the straight section of the die. If the compression ratio of the die is too small or the straight section is too short, the product will not be dense and affect the physical properties of the Aluminum Tread Plate.

3. Poor convergence of the split ribs: For this case, the length of the ribs and the outer surface, the ribs and the ribs at the confluence should be increased appropriately, or the compression ratio should be increased to solve the problem. The change of the die pressure can be changed by changing the length of the straight section of the die. To adjust the flow resistance, different compression ratios can be selected to change the extrusion pressure during the mold design stage, but note that the compression ratio of the machine head should be adapted to the compression ratio of the extruder screw, and the extrusion process can be adjusted by changing the formulation. Parameters, increase the perforated plate to change the melt pressure.

The above is the common brittleness of Aluminum Tread Plate products. When purchasing products, users must choose those companies with high reputation and excellent strength to purchase their own products, and avoid delays in buying products that are not up to standard. Your own normal production.