02-11-2018, 06:09 AM
State T6 and 6061 aluminum T651 difference: under normal circumstances, stress will be greater in the T6, processing will be deformed, most suitable for machining status should be T651, he is conducted on the basis of T6 stretched to eliminate internal stress of 6061 aluminum alloy is the main alloying elements magnesium and silicon, and the formation of Mg2Si phase. If contains must volume of manganese and chrome, can in the and iron of bad role; sometimes also added few of copper or zinc, to improve alloy of strength, and and not makes its anti-corrosion sex has obviously reduced; conductive material in the also has few of copper, to offset titanium and the iron on conductive sex of bad effect; zirconium or titanium can refinement grain and control again Crystal organization; to improved can cutting performance, can joined lead and bismuth. Mg2Si in solid solution in aluminium, alloys with artificial aging function. 6061 aluminum alloy of the main alloying elements magnesium and silicon, a medium strength, good corrosion resistance, weldability, oxidation is better.
Alcoa 6061 with processing performance excellent, good corrosion resistance, toughness and deformation, color film after processing easier, excellent oxidation and other excellent features.
An Al-mg-SI alloy, medium strength, good ductility and excellent corrosion resistance. In particular, without stress corrosion cracking, its excellent weldability, corrosion resistance and good cold, is a widely used. alloys of great promise. Anodizing, or painted on enamel, adapted for building materials. It contains a small amount of Cu and strength above 6063, but quenching of high sensitivity than 6063, cannot achieve after squeezing air quench the need to rethink the solution heat treatment and quenching and aging, to obtain a higher strength.
Alcoa 6061 with processing performance excellent, good corrosion resistance, toughness and deformation, color film after processing easier, excellent oxidation and other excellent features.
An Al-mg-SI alloy, medium strength, good ductility and excellent corrosion resistance. In particular, without stress corrosion cracking, its excellent weldability, corrosion resistance and good cold, is a widely used. alloys of great promise. Anodizing, or painted on enamel, adapted for building materials. It contains a small amount of Cu and strength above 6063, but quenching of high sensitivity than 6063, cannot achieve after squeezing air quench the need to rethink the solution heat treatment and quenching and aging, to obtain a higher strength.