<p>
Aluminium strips are widely used in manufacturing industries such as radiators, cables, transformers and so on. The
aluminum strip is obtained by slitting
aluminum coil of given materials and thicknesses. For example, <strong>
aluminium strip 1mm</strong> is processed by cutting 1mm thick
aluminium coil into strips of the desired width. The precautions for the strips during slitting are as follows.</p>
<p>
The current
aluminum strip slitting machine can keep the width tolerance between 0.05mm and 0.1mm, so the slitting unit must be set by the operator, and the production can be started after the calibration, and the problem of large dimensional deviation must not occur. The burr phenomenon at the edge of the
aluminium strip is mainly caused by the cutting tool. If the edge burr is found to be serious, stop production immediately and find the cause.<br></p>
<p>
The
aluminum coil is usually laid flat when it is cut, or it can be placed vertically. The
aluminum strip should be tightly wound on a steel or aluminum or equivalent die when slitting. The inner diameter of the die is required to be 100+2 mm, 150-2 mm, 204+2 mm, 406. +3 mm. The length of the die of the slitting <strong>
aluminium strip</strong> should be the same as the width of the aluminum-plastic composite strip, and the end of the strip protruding composite strip should be less than 1 mm, and the length of the unsplit aluminum-plastic composite strip should be 5-10 mm beyond the side of the composite strip. According to the supply and demand contract, the
aluminum strip can also be wound on other sizes of dies.</p>
<p>
These are precautions in slitting
aluminium strips. Hope it’s helpful. We supply <strong>
aluminium strip/coil for transformer </strong>and other end products. Welcome to contact us!</p>